Print your own “Razor Blade Holder” so you never have exposed razor blades on your desk again.
Two versions available, one with a lock, the other does not. You will be sold both.
Print with 3 walls, 10% infill, Horizontal Expansion = -.175, no supports, 50% speed on the first 5 layers. When finished, remove the support nub under the keyed cylinder before inserting the razor blade, and then finally insert the blade holder into the body.
Print your own “Plier, Filament Clipper, and Tweezer Organizer”
You will need a print bed 115mm x 90mm, 71g of material. And about 6 and a half hours.
In mine, I have 5 sets of pliers for my wire wrapping kits, my PLA filament blue snips, three different sets of tweezers, a pen, and both my NoCloggers.
Print your own “3D Printer Removable Maintenance Organizer Tray”
You will need a print bed 205mm x 100mm and 220g of material. Print the housing with supports on.
It has storage for multiple hex keys, super glue, snips, MicroSDs, wrenches, scrapers, nozzle needles, nozzle wrenches, and Capricorn tube flushers.
Print your own “3D Printer Removable Maintenance Organizer Tray”
You will need a print bed 205mm x 100mm and 220g of material. Print the housing with supports on.
It has storage for multiple hex keys, super glue, snips, MicroSDs, wrenches, scrapers, nozzle needles, nozzle wrenches, and Capricorn tube flushers.
Print your own Standing Desk Balance Board Ball at home. Follow a simple instructional list, and make one for a fifth the cost.
You will need a print bed 150mm x 150mm and 275g of material.
Print your own “Simple 3D Print Tool Organizer”
You will need a print bed 80 x 80mm and 110of material. When printed top side down, supports will not be needed
It has storage for multiple hex keys, snips, wrenches, scrapers, nozzle needles, nozzle wrenches, and tweezers.